







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Whitney, NV: What the Job Actually Takes
Door installation in Whitney, NV typically runs $450 to $1,800 per door for a standard interior or exterior replacement, and most single-door jobs wrap up in one day once the unit is on site. Larger scopes, like a detached workshop’s oversized roll-up or a run of five exterior doors on a ranch house, push toward the high end and can stretch to three days. Call (844) 797-4406 for a free on-site estimate.
How We Run a Door Installation Job in Whitney, Start to Finish

Every door job has the same skeleton. Where the days add up is in what we find once the old unit comes out.
Stage 1: Measure and order (day 1 to day 10)
We measure each opening down to the sixteenth of an inch, note the wall thickness, check for square, and confirm the swing direction you want. On exterior doors we look at the threshold height and whether the slab has heaved, which is common on older Whitney ranch homes. Then we order. Standard stock sizes land in a few days; a custom width, an arched top, or a heavier workshop door can take two to three weeks. That ordering window is the one part of the job homeowners don’t see, so we put it in writing on the estimate.
Stage 2: Demo and prep (a few hours)
Day-of, we pull the old door and frame, vacuum the cavity, and check the rough opening for rot, water damage, or out-of-square framing. Desert homes hold up well, but we do find soft jambs behind poorly flashed exterior doors where monsoon splash has worked its way in. If the framing is sound, we move straight to shimming. If it isn’t, we tell you before we cover it up and price the repair separately.
Stage 3: Set, shim, and fasten (half a day)
We set the new unit plumb and level, shim the hinge side first, and fasten through the frame per the manufacturer’s schedule. This is the stage that decides whether the door closes with two fingers or drags at the top corner every summer. It’s also where we cut the strike plate and drill for hardware, so you’ll want to have your knob, deadbolt, or handle set picked out before this day.
Stage 4: Flash, seal, and finish (a few hours)
Exterior doors get flashing tape, backer rod, and a bead of exterior sealant on the sill and jambs. That’s what keeps UV and monsoon rain out of the wall cavity. Interior doors get casing and, if you’re reusing existing trim, we match the profile as close as we can. At this stage you decide on paint versus stain and whether you want us to prime or leave it bare for your painter.
Stage 5: Adjust and walk (30 minutes)
We cycle the door a dozen times, adjust the hinges or closer, and confirm the latch catches clean. You get a walkthrough on operation and care, and the workmanship is covered under our 730-Day Done Right Promise. If it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Options You’ll Actually Choose Between
- Steel exterior doors: the workhorse for Whitney. They hold up to intense sun, resist warping in the heat, and start around $600 installed for a standard slab. The trade-off is that a deep dent doesn’t come out, and they can rust at the bottom edge if the sill isn’t kept sealed.
- Fiberglass exterior doors: $700 to $1,400 installed. They take UV without fading the way a cheap steel door’s finish can, and they mimic wood grain convincingly. Heavier than steel, so hinge quality matters.
- Wood exterior doors: $900 to $2,000+. Beautiful on a mid-century ranch, but in our climate they want re-sealing every couple of years or the sun works the finish and the wood checks. Only worth it if you’ll maintain them.
- Hollow-core interior doors: $250 to $500 installed. Light, cheap, fine for closets and a spare bedroom. They transmit sound and won’t survive a slammed door with a heavy hand.
- Solid-core interior doors: $400 to $800 installed. Better sound control and a heavier feel. This is what we recommend on bedrooms facing a busy street.
- Oversized and workshop doors: for a detached garage or shop, a heavy-duty insulated roll-up or a set of double outswing doors costs $1,800 to $4,500. The frame and header have to be right; a door this heavy will reveal a weak opening fast.
On the panel itself, the big call is glazing and energy rating. Whitney’s afternoon sun is brutal, so a low-E glass panel on a west-facing exterior door pays for itself in comfort long before it pays back in energy savings. We install trusted brands, and if you’re coordinating door color and style with the rest of the house, it’s often part of a full Windows & Doors in Whitney scope we can price in one visit.
What Door Installation Costs in Whitney, NV

Plan on $450 to $1,800 per door installed for typical residential work. A single hollow-core interior door sits at the bottom of that range; a fiberglass or steel exterior door with new hardware lands in the middle; a heavy shop door or a custom unit goes over the top. Here’s what moves the number:
- Door type and grade. A hollow-core slab and a solid-core slab differ by a few hundred dollars in material alone.
- Opening condition. A clean, square rough opening is a straight install. Rot, capped-over framing, or a slab that’s heaved adds repair time.
- Hardware. A builder-grade knob and a keyed smart deadbolt are not the same line item. We price hardware separately so there’s no surprise on the invoice.
- Count and access. One door has a trip charge built in; a set of five in the same house spreads that cost and brings the per-door price down.
- Permit scope. A like-for-like swap usually doesn’t need one, but a new opening or a door that changes the wall’s structural path does. That’s a separate line, and we tell you up front which bucket you’re in.
Our estimates are written line-item, and the number you see is the number you pay. If we open a wall and find something we couldn’t see during the estimate, we stop, show you, and quote the fix before we proceed. The work is backed by the 730-Day Done Right Promise. Call (844) 797-4406 to schedule your free estimate.
See the difference
Before
After
Before
After
Before
AfterWhy Whitney Homes Change the Door Job
Whitney sits unincorporated, which means permits and inspections go through Clark County’s Department of Building & Fire Prevention, not a city building department. That distinction is real: a project that would be routine on a Las Vegas city permit can mean a different review timeline and a different inspector schedule on the county side. We plan around it, and we tell you what the county will want to see before we pull anything.
The housing stock shapes the work too. A lot of Whitney is mid-century to late-20th-century ranch homes, and a good share of those still have original single-pane exterior doors and worn interior slabs. On the older houses we often find door openings that have settled a little out of square, and thresholds that want re-flashing after years of UV baking the sealant. Newer infill tends to be square and straightforward. When we cover Whitney, we scope the opening before we quote, so the estimate reflects what the house actually needs rather than a best guess.
One more thing for acreage properties: a detached shop or garage door is a heavier animal than the front door. It needs the right frame and a heavy-duty hinge or opener, and doing it right in one trip matters when the nearest hardware run is a 20-minute drive. Homeowners here tend to agree with that. While we’re out, a lot of folks ask about Cabinets & Countertops in Whitney for the adjoining kitchen, or a Garage Conversion ADU in Whitney that turns a shop into living space, and door work pairs naturally with both.
For a broader view of what we handle across the trade, see our Windows & Doors service hub.
Serving Whitney, NV – Our Local Coverage Area
We serve Whitney and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Door Installation in Whitney

A single door is usually done in one day. A set of five interior doors takes one to two days, and a heavy exterior or workshop door takes a day plus the ordering window, which runs a few days for stock sizes and two to three weeks for custom. Call (844) 797-4406 for a timeline on your specific door.
Usually not for a like-for-like swap in the same opening. A new opening, a wider door that changes the wall structure, or an exterior unit in some cases can trigger a county permit through Clark County’s building department. We tell you which category your job falls into before we pull anything. Call (844) 797-4406 to confirm for your door.
Yes, in most cases the existing opening is reused and nothing structural moves. A wider door or a relocated opening changes that, and we’d quote the framing work as its own line item so you can see exactly what it costs before you decide.
Typical residential work runs $450 to $1,800 per door installed. Interior hollow-core sits at the low end, exterior steel or fiberglass in the middle, and heavy-duty shop or custom doors above that. Call (844) 797-4406 for a written line-item quote, free of charge.
All of our door installation is covered by the 730-Day Done Right Promise. If it’s not done right, we make it right, and that’s in writing. Call (844) 797-4406 to book your estimate.
Get a Free Door Installation Estimate in Whitney
Tell us what door and where, and we’ll come out, measure the opening, and leave you with a written line-item price. No pressure, no vague number. We schedule around your day, and the estimate is free. Call (844) 797-4406 to book your on-site estimate for door installation in Whitney.
Written by the team at Groundwork Construction Co.












