







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Enterprise, NV: What to Expect
Asphalt Driveways & Resurfacing in Enterprise runs $3,500 – $9,000 for a new asphalt drive, and most full-depth installs finish in three to four working days. Resurfacing an existing drive usually costs less and takes a day or two less, depending on how much base repair the surface needs. Call (844) 797-4406 and we’ll get a free on-site estimate on the calendar.
Key takeaways
- New asphalt paving in Enterprise: $3,500 – $9,000 for a typical two-car drive.
- Full replacement where the base has failed: $5,000 – $14,000.
- Cure time matters here. Plan on staying off the new surface for 3 – 7 days in summer heat.
- HOA architectural approval often comes before the permit. We help you sequence both.
How our asphalt paving process works, stage by stage

Asphalt is unforgiving about prep. Most of the failures we get called out to fix in Enterprise trace back to a thin base or a rushed compaction pass, not the asphalt itself. Here’s the sequence we actually run.
Stage 1: Site visit and written estimate (day 0)
We walk the drive, measure the square footage, check the existing base by probing and looking at edge condition, and note drainage. On sloped lots near the foothills, we look hard at where water leaves the driveway. You get a written line-item quote: excavation, base, asphalt tonnage, compaction, and any drainage or retaining work, with the number fixed up front.
Stage 2: Demo and excavation (day 1)
We remove the old surface and any failed base, then cut down to the subgrade depth the new section needs. A typical residential drive gets a 4-inch compacted base under a 2-to-3-inch asphalt lift. On softer engineered fill, we go deeper. Expect a full day of demolition for a standard two-car drive, longer if there’s concrete or a thick failed section to break out.
Stage 3: Base prep and grade (day 1 into day 2)
We bring in crushed aggregate, spread it in lifts, and compact each pass with a plate or roller. Grade gets set to shed water away from the house and garage. This is where a good crew spends time. You’ll see us verifying slope with a level, not eyeballing it. On foothill lots with retaining walls, this is also when we confirm the wall is holding and won’t push water back onto the new drive.
Stage 4: Paving (day 2 or 3)
Hot-mix asphalt goes down at 2 to 3 inches compacted, rolled while it’s still hot and workable. Edge lines get shaped, and we set the transitions at the apron and any garage entry. This is the stage where you decide on a finish for the surface and confirm the drainage slopes. Most drives pave in a single day.
Stage 5: Cure and hand-off (days 3 through 10)
Fresh asphalt cures over about 6 to 12 months to full hardness, but it’s drive-ready in 3 to 7 days depending on heat. During Enterprise summers, when the surface hits 105°F and up, we schedule paving for early morning so the mix isn’t stiff by the time it’s rolled. You get a walkthrough, care instructions, and the work backed by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The asphalt options you’ll choose between
Most of the decisions land in a single conversation. Here’s what actually changes the job.
- New full-depth install vs. resurfacing. A full install replaces the base and asphalt. Resurfacing overlays the existing surface when the base is still sound. Resurfacing costs less but only works if the foundation is intact. We won’t sell you an overlay on a failed base.
- Asphalt thickness. A standard residential drive gets 2 to 3 inches compacted over a 4-inch base. Heavier vehicles, RVs, or a steep foothill grade push us toward 3 inches and a deeper base. More material, higher cost, longer life.
- Base depth and material. Crushed aggregate base, compacted in lifts, is the standard. Engineered-fill lots sometimes need deeper base or a geotextile fabric layer to keep the subgrade from pumping. That fabric is a small line item with a big payoff on soft ground.
- Drainage and edge treatment. On sloped Enterprise lots, we often add a channel drain or a swale to move monsoon runoff away from the garage. Edge restraints keep the asphalt from raveling at the sides.
- Surface finish. Standard asphalt is the default. A seal coat applied after the cure extends life and locks in the color. Wear-course choices affect both look and longevity.
What Asphalt Driveways & Resurfacing costs in Enterprise, NV

Plan on $3,500 – $9,000 for a new asphalt driveway in Enterprise, and $5,000 – $14,000 if the base has failed and the whole drive needs replacing. Those ranges hold for a typical two-car drive. Here’s what moves a job to the low or high end:
- Square footage. A single-car drive lands near the bottom of the range. A long pull to a three-car garage or an RV pad pushes toward the top.
- Existing base condition. A sound base means a straightforward install. Failed base, buried concrete, or tree-root disruption means excavation, haul-off, and new aggregate, which adds real cost.
- Grade and slope. Foothill lots with engineered fill and retaining walls need more base work, drainage, and sometimes a thicker section to hold up.
- Drainage scope. A simple swale is cheap. A channel drain tied into a yard system or a new retaining wall is not.
- Access and staging. Tight streets, gate codes, or a long haul to the dump site add labor and truck time.
Your written estimate itemizes excavation, base, asphalt quantity, compaction, and drainage, so you can see what’s included. Some quotes leave out haul-off, base repair, or drainage, then add it mid-job. Ours doesn’t, and the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Enterprise homes specifically do to asphalt work
Enterprise is the southwest growth corridor, defined by master-planned subdivisions like Southern Highlands and Mountain’s Edge spreading toward the Sloan and Blue Diamond foothills. That means we’re working on sloped, engineered-fill pads with retaining walls, not flat infill. On these lots, drainage and base stability drive the whole job: water has to leave fast and controlled, or it finds the garage. Spring and summer monsoon washes are the real test. HOA communities here also require architectural approval before paving, and we’ll help you read the rules and sequence the permit. On lots backing onto open desert, ember-resistant detailing and defensible-space standards shape what we use at the edges. For a wider look at the full driveway scope, see our Driveway & Pavers in Enterprise page, and homeowners often pair this with Chain Link Fence in Enterprise to set the property line after the new surface goes in. When a project includes a detached structure or an ADU Site Prep & Utilities in Enterprise build, we coordinate the driveway grade with the site work.
Serving Enterprise, NV – Our Local Coverage Area
We serve Enterprise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Asphalt Driveways & Resurfacing in Enterprise

Most residential installs take three to four working days, with a cure period of 3 to 7 days before you park on it. Demolition and base prep eat the first two days; paving is usually a single day in good weather. Call (844) 797-4406 for a schedule made for your property.
In most Enterprise subdivisions you’ll need HOA architectural approval before work starts, and some projects require a permit depending on how the drive ties into the street and drainage. We help you identify both, read the HOA rules, and line up the inspections so the job doesn’t stall.
We can resurface when the existing base is still sound – the asphalt holds up well as an overlay in that case. If the base has failed or water has worked underneath, a full replacement is the honest call. We probe the base during the estimate and tell you which one your drive needs.
New asphalt runs $3,500 – $9,000, resurfacing costs less, and full replacement where the base failed runs $5,000 – $14,000. Square footage, base condition, slope, and drainage scope move the number most. Call (844) 797-4406 for an exact quote – estimates are free.
Every asphalt job we do is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. You also get care instructions for the cure and the first months, so the surface settles in properly. Call (844) 797-4406 with any questions during the cure.
Get a free asphalt estimate in Enterprise
Paving is a decision worth a real conversation, not a phone quote. We’ll come out, measure your Enterprise drive, look at the base and drainage, and give you a written line-item estimate with a fixed number. It’s part of our Driveway & Pavers work, and we back it with the 730-Day Done Right Promise. Call (844) 797-4406 to schedule your free on-site estimate.
Written by the team at Groundwork Construction Co. of Enterprise.












