







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Henderson, NV: What It Takes and What It Costs
Door installation in Henderson typically runs about $650 to $3,200 per door installed, depending on whether it’s an interior slab swap or a full exterior entry system with a new frame. A simple interior door hung and trimmed is a half-day job; an exterior entry door with new framing, flashing and hardware is usually a two- to three-day project. Homes in Green Valley and Anthem often need the longer version because of what’s behind the trim. Call (844) 797-4406 and we’ll walk you through what your specific door needs.
How We Hang a Door, Start to Finish

Every job starts the same way: somebody measures the actual rough opening, not the door you’re replacing. A door that “looks like a 36-inch” can be a 34, a 36, or something a previous owner framed by hand. Those measurements decide everything that follows.
Stage 1: On-site measure and scope (day 1, about an hour)
We verify the rough opening, check the frame for square and plumb, confirm which way the door swings, and look at the threshold and sill. This is also where you decide the big question: same size and same location, or a wider opening, a sidelight, or a relocation. That one decision is the single biggest cost driver, so we settle it before quoting.
Stage 2: Order and lead time (1 to 4 weeks depending on spec)
Stock doors go in fast. A custom entry door from Andersen or Pella is a build-to-order item and waits on the factory. We order the door, the frame, the hardware and the finish as one package so nothing shows up mismatched. You approve the exact door, color and hardware finish before we place the order.
Stage 3: Demo and prep (day one on site, 2 to 4 hours)
Old door and trim come out, and we inspect what the wall has been hiding: water staining, rot at the sill, cracked stucco around the opening. In Henderson’s sun-baked exteriors, a failed seal shows up as rot at the bottom corner faster than people expect. We repair the framing before anything new goes in.
Stage 4: Set, shim and seal (most of the second day)
The new frame gets shimmed plumb and square, fastened, and insulated. Exterior doors get flashing taped at the head and sill and a bead of exterior-grade sealant that can take desert UV without chalking out in a year. Interior doors get hung, latched and checked so the gap is even on all four sides.
Stage 5: Trim, hardware and final walk (day two or three)
Casing goes on, hardware gets installed and tested, and we hand you the keys and deadbolt. You walk every door with us. If a latch catches or a door rubs, we fix it before we leave, and the work sits under our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Door Options You’ll Choose Between
- Interior doors, hollow-core vs. solid-core: Hollow-core runs about $150 to $400 installed and is fine for closets and secondary rooms. Solid-core costs $350 to $700 installed, feels heavier, cuts sound between rooms, and holds up better in daily traffic.
- Exterior entry, fiberglass vs. steel vs. wood: Fiberglass holds color and resists the sun best in a desert climate; steel is strong and cheaper but dents and can transmit heat; wood looks warm but wants more maintenance against dry heat. Expect $900 to $2,500 installed for the door alone.
- Impact-rated vs. standard exterior: Impact glass adds cost but delivers security and storm resistance, and it’s a real consideration on Henderson entry doors facing west or south.
- Frame and trim: A pre-hung unit in a new frame is cleaner and faster than reusing an old frame. New casing in a modern profile or a period profile near Water Street changes the look more than the door itself.
- Smart and rolling-code hardware: Keypad deadbolts and rolling-code remotes are a natural upgrade on exterior doors, especially on homes where the garage or side entry is the door everyone actually uses.
- Slab vs. pre-hung: A slab swap reuses the existing frame and is cheaper, but only works if the frame is straight and sound.
What Door Installation Costs in Henderson, NV

Most Henderson door installation lands between $650 and $3,200 per door, and a whole-house interior package of six to eight doors usually comes in around $3,000 to $6,500 when ordered and installed together. The range is wide because of a handful of variables.
- Door type and material: Interior hollow-core sits at the low end; an exterior fiberglass entry with impact glass and premium hardware sits at the top.
- Opening changes: Widening an opening, adding a sidelight, or moving a door means reframing, drywall and stucco work, and that can add $800 to $2,500.
- Condition behind the trim: Hidden rot or a failed sill adds repair time. We flag it in the estimate, not after demo.
- Hardware and finish: Standard knobs vs. keypad deadbolts, plus premium finishes, move the number by $100 to $500.
- Permits: A like-for-like swap usually doesn’t need one; structural changes to an opening do, and we pull it and pass inspection.
A written estimate from us lists the door, frame, hardware, labor, disposal and permit line by line. Not included: painting or staining the interior wall if you want it refinished, and any structural repair found after demo that nobody could see. Upfront pricing means the number you see is the number you pay, and 0% financing for 18 months plus $1,000 off projects over $10,000 helps on larger packages.
See the difference
Before
After
Before
After
Before
AfterWhat Henderson Homes Specifically Do to This Job
Henderson is a city of two construction realities stacked on top of each other. Out south and east, Green Valley, Anthem and the Inspirada and Lake Mead corridor are master-planned build-outs where doors are hung on brand-new framing and the job is predictable. Around the original downtown and Water Street, the stock runs much older, and openings are rarely square. We measure twice there.
Henderson also writes and enforces its own permitting and inspections separate from Clark County, so a job that changes an opening or adds an exterior door has to clear a Henderson inspector who will look at flashing and framing, not just the finished trim. HOAs in the planned subdivisions add their own review on top, especially on exterior door color and style. All of that shapes how we sequence the work, and it’s why the pre-install measurement stage matters so much here.
The desert heat and sun are the other factor. UV destroys cheap sealant fast on stucco exteriors, so we use exterior-grade product rated for the climate. And because many of these homes were built in the 1990s and 2000s, the original doors and seals are simply at the end of their run. If you’re planning this as part of a bigger exterior refresh, it fits naturally with Windows & Doors in Henderson, and homeowners often pair this with Cabinets & Countertops in Henderson during a larger renovation. We cover the whole city, from Henderson‘s older core out to the newest subdivisions.
Serving Henderson, NV – Our Local Coverage Area
We serve Henderson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions: Door Installation in Henderson

Most single-door jobs finish in one to three days. Interior door swaps are typically a half-day each, while an exterior entry with new framing and flashing usually takes two to three days once the door is on site. Custom orders add one to four weeks of lead time before installation begins. Call (844) 797-4406 to schedule a free estimate and lock in your timeline.
A straight like-for-like swap usually needs no permit, but changing an opening or adding a new exterior door generally requires one through Henderson’s own permitting process. We tell you up front which category your job falls into, pull the permit when required, and pass the inspection before we call it done. Call (844) 797-4406 with your address and we’ll tell you exactly what applies.
Plan on roughly $650 to $3,200 per door installed, with whole-house interior packages running $3,000 to $6,500. The exact figure depends on the door type, hardware and whether the opening changes. We give you a written line-item estimate so you see where every dollar goes. Call (844) 797-4406 for an exact quote; estimates are free.
Yes, when the existing frame is straight and sound, a slab swap reuses the frame and saves money. If the frame is out of square or showing rot, a full pre-hung replacement is the better call. We check the frame during the measure visit and tell you which route makes sense. Call (844) 797-4406 to schedule that measurement.
Every door we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That covers workmanship on the install, the sealing and the hardware fitting. Manufacturer warranty on the door itself comes with the product. Questions about coverage? Call (844) 797-4406 and a live person answers, any hour.
Get a Free Door Installation Estimate in Henderson
If you’re ready to price door installation in Henderson, call us at (844) 797-4406 to set up a free on-site estimate. A live person answers around the clock, we measure your actual openings, and you leave with a written line-item quote and a clear timeline. If the job is bigger, homeowners often pair this with a Garage Conversion ADU in Henderson for a turnkey approach. See the full Windows & Doors range too. Estimates are free, and financing at 0% for 18 months is available. Our technicians have up to 12 years of experience, and every job is backed by our 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.












