







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterWalk-In Shower Installation in Enterprise, NV
A walk-in shower installation in Enterprise, NV typically costs between $3,200 and $9,800 for a full tear-out and replacement, with most homeowners landing near the $5,400 mark for a curbless tile job with a frameless glass panel. The work itself usually runs two to four days once materials are on site, though custom tile and plumbing relocation push that longer. We install walk-in showers as part of our Bathroom Remodeling in Enterprise work, which means the shower doesn’t get treated as a standalone insert bolted into a half-finished room. Call (844) 797-4406 for a free estimate and a real conversation about what your bathroom can actually hold.
Here’s what matters in this part of the valley. Enterprise sits on ground that shifts, and a lot of the housing stock went up fast through the 2000s and again through the 2010s. We pull more shower pans than you’d expect in neighborhoods like Southern Highlands and Mountain’s Edge because the original pre-formed bases were set on subfloor that wasn’t properly prepped, and after fifteen summers of 110-degree heat cycling through the walls, the sealant gives up. A walk-in shower, done right, solves that permanently. Done cheap, it becomes the next thing you tear out.
We’ve been doing bathroom construction across the Las Vegas valley since 2014, and our technicians bring up to 12 years of hands-on experience to jobs like this. Every installation is covered by our 730-Day Done Right Promise. If the pan isn’t right, the tile lippage is off, or water finds a path it shouldn’t, we come back and fix it. That promise runs two full years, which is roughly eight Nevada summers longer than most of what you’ll be quoted elsewhere.
Key Takeaways
- Most walk-in shower installations in Enterprise run $3,200 to $9,800, depending on tile choice, glass, and whether plumbing moves.
- Curbless and low-curb entries require the right slope and waterproofing; getting it wrong is the number one cause of shower failures we see.
- Permits are generally required when you move plumbing or change the shower footprint, and Clark County inspections happen at rough-in and final.
- Our 730-Day Done Right Promise covers workmanship on every installation; the number you’re quoted upfront is the number you pay.
- Calls are answered by a live person 24/7, so a shower leaking through the ceiling at 11pm gets a human, not a voicemail prompt.

When You Need Walk-In Shower Installation
Some things are a style choice. Others are a problem waiting to get worse. Here’s how Enterprise homeowners usually end up calling us.
- The shower pan is soft underfoot. Step into the shower and the floor flexes or squishes. In our dry climate, we see this most in homes built between 2003 and 2008 where the original fiberglass base cracked along the drain slope. That flex is a sign water has already been getting under the pan for a while.
- Someone in the house can’t safely step over a tub wall anymore. A walk-in shower with a low or zero curb is the standard answer for aging-in-place. We also add blocking for grab bars during framing, because adding it later means tearing out finished tile.
- The grout is a permanent maintenance project. Hairline cracks in shower grout are routine here, not a sign of a bad contractor. But if you’re re-caulking every spring and still finding moisture, the shower has exhausted its service life and a rebuild makes more sense than another tube of sealant.
- You’re reconfiguring the room. Taking out a tub to gain floor space, or swapping a tub-and-shower combo into a single large walk-in, is one of the most requested changes in Mountain’s Edge and Southern Highlands, where the secondary baths are often tight.
- The glass is fogged or scratched. Hard water in the valley leaves mineral deposits that etch tempered glass over time. If the enclosure is clouded and the shower around it is otherwise sound, you may only need glass and hardware, not a full rebuild. A free estimate will tell you which.
- You’re selling, or planning to within a year. A clean, modern walk-in shower in the primary bath is one of the more reliable returns in a resale, and buyers in this market notice whether the waterproofing was done properly.
Our Walk-In Shower Installation Process
Every installation follows the same sequence, and we say so because predictable process is how you avoid the surprises that make bathroom work stressful.
- Free estimate and design consult. We walk the bathroom, measure, look at what’s behind the existing surround, and check where the drain and supply lines sit. You get a written price before anyone swings a hammer. If the scope is unclear until demolition, we build that into the agreement rather than discovering it mid-job.
- Permitting and protection. If we’re moving plumbing or changing the footprint, we pull the permit and arrange Clark County inspections at rough-in and final. Floors and adjacent rooms get covered before demolition. No shortcuts here, since unpermitted plumbing comes back at resale.
- Demolition and framing. Out comes the old shower, with any hidden water damage addressed as part of the daily progress conversation. We add blocking where a bench or grab bars will go, and confirm the subfloor is flat and dry before anything goes back in.
- Plumbing rough-in and waterproofing. Valve and drain are set to the new layout, then we sloped the pan to the drain and install a bonded waterproofing membrane system on walls and floor. This is where most shower jobs fail, and it’s the step we refuse to rush. Water test, then inspection.
- Tile, glass, and trim. Tile goes in with attention to lippage and layout around niches and benches, then grout, sealant, and the glass panel or door go on. Frameless glass looks cleaner but needs framing that supports it, which is why we plan it during framing, not after tile.
- Final walkthrough. We run the water, check the slope drains completely, review what we did, and hand over care instructions. You’ll see the 730-Day Done Right Promise in writing, and the number you were quoted is the number you pay.
We select materials from a curated set of brand partners rather than whatever the supply house has on the shelf that week. Kohler fixtures are the most common shower valve we install, and they’re a good fit for this market because the ceramic cartridges hold up to our hard water better than the budget valves you’ll find in most builder-grade showers.

Walk-In Shower Installation Pricing in Enterprise
Walk-in shower installation in Enterprise runs from about $3,200 for a straightforward tub-to-shower conversion with an acrylic pan and tile walls, up to $9,800 or more for a curbless walk-in with a bench, niche, frameless glass, and custom large-format tile. The biggest cost driver isn’t the shower itself. It’s what we find under the old one and how much plumbing has to move.
| Line Item | Typical Range in Enterprise |
|---|---|
| Tub-to-shower conversion, standard acrylic pan | $3,200 – $5,000 |
| Curbless walk-in with sloped pan and tile | $5,500 – $8,200 |
| Frameless glass enclosure | $900 – $2,400 |
| Tile work (walls, floor, niche, bench) | $1,200 – $4,000 |
| Plumbing relocation (drain, valve, supply) | $400 – $1,800 |
| Water damage repair to subfloor or framing | $300 – $2,500 |
| Permit and inspection fees | $200 – $600 |
The range is wide because the middle of it is where real work lives. A shower that costs $5,400 here includes the waterproofing membrane, a properly sloped pan, and a permit if one’s required, all things a $2,800 handyman quote usually leaves out. We’d rather show you the difference on paper than have you find out at year three.
What affects the price most:
- Tile choice. Large-format porcelain costs more per square foot and more to install than standard mosaic, but it means fewer grout lines to maintain in a dry climate.
- Curb vs. curbless. A curbless shower requires a recessed or sloped floor assembly for drainage, which adds labor. It’s worth it for aging-in-place, and it’s the option most requested in primary baths in Enterprise.
- Hidden damage. We don’t know what’s under the old shower until demolition. When we find rotten subfloor or a cracked pan, we quote the repair before proceeding. No surprise change orders tacked onto the end.
- Glass and hardware. Frameless glass with solid brass hardware runs higher than a framed enclosure, and it needs framing support planned from the start.
We keep the estimate transparent, and we back it with financing: 0% for 18 months, plus $1,000 off projects over $10,000. For a shower tucked into a larger bathroom remodel, that combination usually closes the gap between what you want and what you were planning to spend. Call (844) 797-4406 for a free estimate and a written number, not a ballpark.
FAQs – Walk-In Shower Installation
How much does a walk-in shower installation cost in Enterprise, NV?
Most walk-in shower installations in Enterprise cost between $3,200 and $9,800, with a typical mid-range tile job landing around $5,400. The price depends mainly on tile choice, whether the shower is curbless, how much plumbing moves, and what we find under the existing shower. Call (844) 797-4406 for an exact quote: estimates are free, and the number you get is the number you pay.
Do I need a permit for a walk-in shower in Enterprise?
Yes, in most cases. Clark County requires a permit when plumbing is relocated or the shower footprint changes, and inspections happen at rough-in and final. A straight replacement in the same location sometimes doesn’t require one, but we’ll tell you honestly which situation you’re in before we start. Pulling a permit protects you at resale and keeps the work accountable to an inspector as well as to us.
Can you finish my walk-in shower in a single visit?
Most full installations take two to four days, not one. Tile needs time to set, waterproofing needs to cure, and there’s an inspection built into the schedule when a permit is involved. The exception is a like-for-like acrylic shower replacement, which can occasionally land in a day once materials are on site. We’ll give you a realistic timeline up front, because a rushed waterproofing layer is exactly how these showers fail.
Is a curbless shower worth the extra cost?
Curbless is worth it if someone in the household will use the bathroom for years to come or if you’re planning to age in place. The extra cost usually runs $1,500 to $3,000 over a standard curb, and it comes down to the sloped floor assembly needed to drain properly without a lip. For a shower on a slab foundation, that’s real labor, not a gimmick. Call (844) 797-4406 and we’ll walk through what your bathroom’s floor structure allows.
What happens if the shower leaks during the warranty period?
We come back and fix it. That’s the whole promise. The 730-Day Done Right Promise covers workmanship for two full years, and a shower that leaks within that window from a flashing, membrane, or slope issue is on us. You’ll get that promise in writing, and you’ll have the same number to call that you used to book the job. Live person, 24/7.
Can you match the shower to my existing bathroom?
Yes. We’ll photograph the room, note the tile and trim, and pull samples from the brands we work with to find a close match. Sometimes a perfect match isn’t possible, and we’ll tell you that up front instead of hoping you don’t notice. When the shower and the rest of the room have gone in different directions, we can talk through a small surrounding refresh as part of the larger Bathroom Remodeling scope.
We bring in teammates and subs only after they’ve been background-checked, and they show up in uniform with the material list confirmed the day before. No unmarked vans in your driveway, no crew you can’t identify.
If you’ve been putting up with a sagging shower pan, a fogged glass door, or a tub you can barely climb into, the fix isn’t as far off as it feels. Groundwork Construction Co. of Enterprise handles the whole job: estimate, permit, plumbing, waterproofing, tile, glass, and the final walkthrough. Our brand partners give you real choices rather than whatever’s on the shelf, and our 730-Day Done Right Promise stays with the work long after we’ve cleaned up. Call (844) 797-4406 for a free project estimate and design consult. Live person, 24/7. From foundation to finish line, built to last, backed in writing.
Written by the team at Groundwork Construction Co. of Enterprise, serving Enterprise.


