







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Whitney, NV: What the Job Actually Involves
New asphalt paving in Whitney typically runs $3,500 – $9,000, and resurfacing an existing drive (an overlay over sound base) usually lands well under that. Most residential drives here are finished in two to three days of actual work, but the asphalt then needs about a year to cure before it can be sealed, and summer pours get scheduled early in the morning because ground temperatures push past 140°F by midday. Call (844) 797-4406 and we’ll walk your drive, check the base, and give you a written number before anything gets torn out.
How an Asphalt Driveway Goes In, Start to Finish

Whitney drives are often longer than city lots allow, and several sit in front of detached workshops or RV pads. That changes the sequencing. Here’s the real order of operations.
Stage 1: Site walk and base evaluation (day of estimate)
We measure square footage, check what’s under the existing surface, and look at where water runs off. In Whitney, a lot of older ranch properties have drives that drain toward the house or a shop slab instead of the street, and that has to be corrected before a single ton of asphalt shows up. You decide here whether you’re paving new, overlaying, or doing a full replacement, and we hand you a line-item written estimate with the compaction depth spelled out.
Stage 2: Demo and excavation (day 1)
Existing asphalt, gravel, or caliche gets hauled out. We excavate to a depth that accommodates 4 – 6 inches of compacted aggregate base under a residential drive, deeper where heavier vehicles roll. If your property has an oversized door on a detached shop and you plan to bring equipment trailers across the drive, we spec a thicker section for that span. You’ll see the subgrade exposed at the end of this day, and you should look at it.
Stage 3: Grading and base compaction (day 2)
Base goes down in lifts and gets compacted with a plate and roller, not just dumped and smoothed. Slope is set so water leaves the pavement at roughly 2% and doesn’t pond. A lot of the Whitney failures we get called out to fix trace back to skipped base work under a thin coat of asphalt, so this stage eats the most time on purpose.
Stage 4: Paving and initial rolling (day 3)
Hot-mix asphalt arrives and gets laid at 2 – 3 inches compacted thickness for a residential drive, then rolled while it’s still workable. We schedule pours early in the morning during summer months because the mix cools too fast to compact properly in peak heat. Edges get tamped and the transition at the street and garage apron gets cut clean. You decide at this point whether you want a straight edge or a small curb detail.
Stage 5: Cure and seal window (a year later)
Asphalt cures, it doesn’t dry. Light foot traffic after 24 – 48 hours, vehicles after about three days when the weather cooperates. Sealer goes on after the pavement has had a full season to cure, and the first seal is the one that matters most in the desert sun.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Asphalt Options You’ll Choose Between
The big decisions aren’t cosmetic. They’re about thickness, mix, and what’s under the surface.
- Overlay vs. full replacement: An overlay is faster and cheaper, but only if the base is sound and there’s no alligator cracking. If the base has failed, an overlay just transfers the failure upward in two years.
- Base depth – 4 inches vs. 6 inches compacted: The 4-inch section suits standard cars. Six inches handles a heavy truck, a trailer, or regular shop traffic, and runs several hundred dollars higher on a typical Whitney drive.
- Standard hot-mix vs. polymer-modified mix: Standard mix is fine for most drives. Polymer-modified holds up better against thermal expansion cracking in extreme heat cycles, and it’s worth the step up on long, unshaded drives.
- Sealer schedule: First seal after one year, then every two to three years. Skipping it in Whitney’s UV load means the binder oxidizes and the surface goes gray and brittle faster than it would elsewhere.
- Apron and street transition: A clean cut at the sidewalk or street edge keeps water and debris from catching. Depending on the county right-of-way, that transition may be inspected.
Your roofing and fence choices don’t touch this job, but if you’re doing a full exterior refresh, certain materials age together better than others. Owens Corning and GAF shingles hold their color through the same UV that eats asphalt, and if you’re replacing a shop roof while the drive is torn up, doing both at once saves a mobilization.
What Asphalt Driveways & Resurfacing Costs in Whitney, NV

Asphalt paving typically runs $3,500 – $9,000 for a Whitney residential drive. A full replacement – demo, base, and new asphalt – commonly lands in the $5,000 – $14,000 range. Resurfacing alone is the low end of that when the base is intact.
Four things move the number:
- Square footage and drive length: Acreage properties here often have drives double the length of a city lot. Every extra 500 square feet lands in the hundreds of dollars, not the tens.
- Base condition: If the base is sound, you’re paying for asphalt. If it’s failed, you’re paying to remove, haul, and rebuild – that’s the biggest single swing.
- Access and haul-off: Tight driveways, long pulls from the street, or debris that has to travel a distance to the truck add labor.
- Drainage corrections: Regrading to move water away from a shop slab or the house is a small line item that prevents the largest long-term cost.
Your written estimate spells out thickness, base depth, and haul-off. What it typically doesn’t include is a first-year seal – that’s scheduled separately after cure, and we say so up front rather than hiding it in a call-back.
See the difference
Before
After
Before
After
Before
AfterWhat Whitney’s Housing Stock and Permitting Do to This Job
Whitney is unincorporated Clark County, so driveway work here goes through the county’s Department of Building & Fire Prevention rather than a city building department. Locals who’ve built in unincorporated areas know this can mean different timelines and requirements than a project inside Las Vegas city limits, and it’s one reason we pull and verify permits through the county before demo starts. The housing stock matters too. The mix of older ranch homes and newer infill around ZIP 89122 means we regularly see drives poured decades ago with shallow base, now failing under tree roots and thermal cracking. Summer curing is its own problem – low rainfall is helpful, but ground temperatures mean pours get scheduled early and the surface needs to be handled correctly in the heat.
If you’re adding a detached structure or expanding a shop, many Whitney homeowners pair this with ADU Site Prep & Utilities in Whitney so grading and access are solved once. And if the drive includes a fenced perimeter, Chain Link Fence in Whitney is the usual pairing for keeping equipment and trailers secure behind a shop.
For the full scope of what a driveway project can include across materials, see our Driveway & Pavers in Whitney page. We cover this work across the wider Whitney area, and asphalt is one piece of our full Driveway & Pavers service.
Serving Whitney, NV – Our Local Coverage Area
We serve Whitney and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Whitney

A typical Whitney drive takes two to three working days: one for demo and grading, one for base compaction, one for paving. Larger acreage drives or jobs requiring drainage corrections can stretch to four to five days. Call (844) 797-4406 for an estimate with your specific timeline.
Often yes – because Whitney is unincorporated Clark County, the permit typically goes through the county’s Department of Building & Fire Prevention, especially when the work touches right-of-way or requires grading changes. A straight private-drive replacement may or may not need one, depending on curb cuts and drainage. We verify before we start and put it in writing.
Yes, if the existing base is sound and the cracking is surface-level. If the drive has alligator cracking, sinking areas, or failed drainage, an overlay will fail within a couple of years. Our estimator checks the base with a probing rod and calls it straight rather than selling an overlay that won’t hold.
Resurfacing a typical Whitney drive runs from around $3,500 on the low end, while a full replacement with new base can land near $14,000 for a long drive with drainage work. The difference depends almost entirely on base condition and square footage. Call (844) 797-4406 and we’ll give you a written line-item quote – free.
Every asphalt drive we install is backed by the 730-Day Done Right Promise – if it’s not done right, we make it right. That covers workmanship. Wear-and-tear from the desert sun and normal curing are separate, and your written estimate spells out exactly what’s covered.
Get a Written Estimate for Your Whitney Driveway
Call (844) 797-4406 for a free on-site estimate in Whitney. A live person answers any hour, and an estimator walks the drive, checks the base, and hands you a line-item written quote with base depth and mix spec spelled out – no change orders after the fact. If it’s a resurface, we’ll tell you straight whether the base can handle it.
Written by the team at Groundwork Construction Co. of Enterprise.












